Cannabis Roots oil

2oz smashed up/chopped cleaned and well dried roots.. 300 grams coconut oil(organic virgin should be the only type of coconut oil used).. 2grams black peppercorns, 2grams whole cloves, given a quick smash with a mortar and pestle.. Water.. Put all 'ingredients' in a pot and set heat at 75-80°C for about 8 hours, topping up the water as it evaporates.. When done, place in the fridge til the oil hardens, poke a hole in it and drain the water, then remove the hardened oil(clean it as best you can) and put it in another pot to warm through, the strain it through a cheesecloth or linen and get it on ya!! Then ya can say you're rooted!! Store sealed, in a cool dark place..

Seizures Epilepsy THCA

Seizures/Epilepsy:The Simple Way

Harvesting THCA:

To start you will need the following.

1 ounce good fresh dried bud from any high THC strain. (1 oz)

1 Liter of rectified spirit
(95 percent alcohol)

2 x one-liter glass mason jars

1 Pyrex/glass Oblong Baking Dish 4.5L

Preparation for Extraction

1) Take 1 ounce of dried bud (preferably frangible) from any high THC-strain and crumble it all up (by hand) and place in glass mason jar. (Tip – to make buds dry enough to be frangible/brittle, lay buds on a tray and leave a cool fan blowing air directly on to it for an hour or so.

2) Place a piece of nylon stocking across the mouth of the mason jar holding the crumbled buds, and tie with a rubber band or piece of string. Place in freezer overnight.

3) Place two containers of 500 ml spirit in the freezer (or one liter – you measure out 500ml when the time comes). Freeze containers of alcohol overnight to -17 or -19 degrees Celsius or 0 degrees Fahrenheit.

The Extraction

Now, the idea is to work very quickly to do two, perhaps three, quick rinses before the buds thaw. The freezing process prevents picking up water soluble contaminants from the plant material during the rinse.

4) Pour 500 ml of the frozen spirit onto the frozen buds, slush it around for a bit. After about 90 seconds pour off the liquid through the nylon stocking, and then also through a coffee filter * (to remove small particulate matter) into the glass collection dish.

(*The second mason jar has a coffee filter secured to it, so you pour the alcohol/resin solution through the filter into the second mason jar, then pour that into the glass collection plate)

5) Fill jar again with the remaining 500 ml of alcohol, swish around again, and then pour off the liquid through the nylon stocking and then through a coffee filter into the second mason jar, and then into the glass collection dish.

Sometimes a third wash is possible before thawing so try and do the first two rinses quickly. If you do a third wash you will need additional alcohol.

What is poured into the plate is all the resin without the plant material. This contains your THCA as well as other cannabinoids.

6) The collection plate should now hold about 1 liter spirit and resins. Place a household fan near the plate and blow cool air over the plate for about 24 to 48 hours or until all of the alcohol has evaporated. There is no hurry here ok.

7) The collection plate once evaporated should have a thin film of resin sticking to the glass. It helps to have a flat razor blade or putty knife to scrape up the resin. It’s very sticky, like tar, and it’s easier to work with when very cold (you can pop it in the fridge to harden it).

One ounce should yield about 3 to 5 gms of resin. Keep this stored in the fridge to keep cool and easier to handle.

Making a THCA Tincture

8) Weigh the resin, and put 1gm of THCA resin into a 100 ml bottle and fill with spirit. You will find the resin easier to handle if it is frozen.

9) Test your final result at a lab so you know exactly what you have. Results should show high amounts of THCA a small amount of THC (through natural decarboxylation in the drying/curing process of the buds).

10) Per Canna, “Each patient is taking roughly 2ml/day of the tincture I make. This is broken down into 4 drops 3 times daily, and 1 ml before bed. The results speak for them selves.” “One ounce of high-grade bud produces 3 to 5 grams of resin. That is enough to make 3 to 5 100-ml bottles. Each patient is only using 2ml per day, so each bottle last 50 days.”

This is NOT for sublingual use. It is designed to go down a feeding tube, or be incorporated in juice or custard, etc.

WARNING: DO NOT CEASE CONVENTIONAL AED’s WITHOUT MEDICAL SUPERVISION. IF YOU DO SO YOU CAN LIKELY EXPECT A RECURRENCE OF SEIZURES. Once you commence a THCA therapy there needs to be a period of time for the cannabinoids to fully become effective. If you wean conventional medicines too quickly the patient has high chances of seizures recurring. It is not recommended that reductions in conventional medicines be made within a month of starting a THCA treatment.